PJlink problems

Hello!
 Faced the problem of transmitting PJlink command to Epson L1755U projector. The connection to the projector is OK. From the right side  bare, commands are sent without problems, but I cannot transfer the command from the dashboard or timeline. Maybe I'm doing something wrong. How should the PJlink command be correctly formatted into the dashboard?

Thanks in advance!

Comments

  • Hello @Vladimir,

    If you roll over the "i" icon, you will read the commands available :
    • power "on"
    • power "off"
    • shutter "close"
    • shutter "open"
    • input "DIGITAL 1"

    Use them in the dashboard or the timeline, see attached project.
    Best. Philippe
Sign In or Register to comment.