hello,
work on HELIOS DAC to control KUB 1500 RGB(boomtoneDJ)
Open layer/laserdrawing...
i can do free lines . ok. i can draw. effects not work...??
how i can do animation ?
thks...
Hello @nikola,
The "laser" effect can detect lines or points. Of course the result would be hardly good if you try it with a picture with a lot of contours.
Try with this project :
Please note that lastest beta includes new animation properties for laser-media : selection and phase. It also play .ILD files (still frames or animations).
Best. Philippe
thanks a lot Phillipe !
i just test your project. it work !
but when i do some littles changes, my laser beam shut down...
millumin recognize it ( HELIOS interface) but i lost my light !
after many ways and connection, start computer and the laser beam next millumin...etc
nothing happen...drivers ? it seams that is between Helios /ILDA /laserbeam...
...
ok problem resolved !
kpps rating, on 10kpps it work.
....
Comments
Hello @nikola,
The "laser" effect can detect lines or points. Of course the result would be hardly good if you try it with a picture with a lot of contours.
Try with this project :
Please note that lastest beta includes new animation properties for laser-media : selection and phase. It also play .ILD files (still frames or animations).
Best. Philippe
thanks a lot Phillipe !
i just test your project. it work !
but when i do some littles changes, my laser beam shut down...
millumin recognize it ( HELIOS interface) but i lost my light !
after many ways and connection, start computer and the laser beam next millumin...etc
nothing happen...drivers ? it seams that is between Helios /ILDA /laserbeam...
...
ok problem resolved !
kpps rating, on 10kpps it work.
....