›

not receiving sacn?

mrnissmrniss
in MAIN

hi, does the trial version not allow sacn input?

i'm just trying to test connectivity here, data shows up perfectly fine in sacnview on the same computer, but does nothing in millumin...

Comments

  • MilluminMillumin

    Hello @mrniss,

    sACN is working in trial mode.

    Be sure no other application is using sACN on your computer, then retry.

    Best. Philippe

  • mrnissmrniss

    millumin is the only thing running, at all.

  • MilluminMillumin

    Hello @mrniss,

    A few questions to better understand the situation :

    • if you open the device-panel (CMD+k) : is sACN in red or green ?
    • in the device-panel : is the right network interface selected ?
    • what is your version of Millumin ? 5.14.j ?
    • what is your version of macOS ? 26 ?
    • is Millumin authorized to access local networks (see this article) ?


    Thank you for your answers.

    Best. Philippe

  • mrnissmrniss

    green

    interface is correct (wired usb)

    514j

    tahoe 26.4.1

    network allowed

    i've set this all up correctly, sacnview has the same permissions set and it picks up the sender instantly. no idea what's going on here.

  • MilluminMillumin

    Hello @mrniss,

    Thank you for your answers.

    Is Artnet working correctly ? If the problem persists, could you send (via email) a TeamViewer session or equivalent ?

    Best. Philippe

  • mrnissmrniss

    with artnet enabled, it sees the sender, logs repeat: "detected Artnet node at (IP)", but not data comes into the DMX monitor section.

    same as on sacn, artnetview sees data immediately.

  • MilluminMillumin

    Hello @mrniss,

    This is quite odd. It is like if Millumin was not authorized to listen to the network (at least to sACN/Artnet port).

    Could you send (via email) a TeamViewer session or equivalent ? I am sure it is not something big.

    Best. Philippe

Sign In or Register to comment.