Sending Midi to ETC Ion Lighting Controller

thomasd

I would like to use cue points in Millumin to send a midi signal that trigger lighting cues in the ETC Ion light board. I understand that I must use MilluPlug to send the Midi signal.  Which USB-Midi interface should I use to connect the Millumin computer to the Ion light board?  Will MilluPlug automatically recognize the USB - Midi interface? Thanks

antoineM

Hello @thomasd

Any Midi capable interface will work with Millumin if he is supported on OSX.

It will be recognised by Milluplug. Don't forget to activate it in the settings panel. 

Regards 

Antoine M* 

thomasd

Thank you!