ATEM Mini Extreme ISO: brief flash of previous camera when switching inputs across different layers
Hi everyone,
I'm controlling an ATEM Mini Extreme ISO from Millumin and running into a switching glitch.
What works: when I go from one column to the next with a cut between Camera 1 and Camera 2 on the same layer, the transition is perfectly clean.
The problem: if Camera 2 is on a different layer, the output stays on the current camera for a split second before switching to Camera 2. It feels like the switch command reaches the ATEM slightly too late, as if there's a small delay in triggering the input change when it comes from another layer. This doesn't happen at all when both cameras are on the same layer.
Is this expected behavior when ATEM inputs are spread across several layers? Is there a recommended way to set this up (layer order, timing, a specific option in the ATEM settings) to get a clean, frame-accurate cut regardless of the layer?