Hello Millumin team,
I have an issue with Korg Nanokontrol Studio, i can assign for example de master video on a fader.
This is what i have on the Log
Unless if i use on USB and not on Bluetooth.
Thank you
Hello @Jonathan,
From what I understand, it works correctly via USB but not via Bluetooth, is that right ?
Did you setup MIDI via Bluetooth like this article ? Are you sure your device is sending MIDI V1 (not V2) ?
Best. Philippe
No it doesn't work also with USB .
It work with the button but not with the fader and the wheel
The "pitch wheel" MIDI messages are not supported.
For the faders : are you sure they are configured as "control change" (CC) ? Else what kind of MIDI signal these faders send (Note, ProgramChange, ...) ?
Yes, also on CC, the adress are always unknow
Problème solved with Kord Kontrol Editor
Helllo @Jonathan,
What did you do exactly ?
My guess is that your fader were not sending CC MIDI message, but another kind of message (channel pressure, MIDI V2, ...).
I made a factory reset and i assign a midi port, because the port was CTRL and not a number.
Comments
Hello @Jonathan,
From what I understand, it works correctly via USB but not via Bluetooth, is that right ?
Did you setup MIDI via Bluetooth like this article ? Are you sure your device is sending MIDI V1 (not V2) ?
Best. Philippe
No it doesn't work also with USB .
It work with the button but not with the fader and the wheel
Hello @Jonathan,
The "pitch wheel" MIDI messages are not supported.
For the faders : are you sure they are configured as "control change" (CC) ? Else what kind of MIDI signal these faders send (Note, ProgramChange, ...) ?
Best. Philippe
Yes, also on CC, the adress are always unknow
Problème solved with Kord Kontrol Editor
Helllo @Jonathan,
What did you do exactly ?
My guess is that your fader were not sending CC MIDI message, but another kind of message (channel pressure, MIDI V2, ...).
Best. Philippe
I made a factory reset and i assign a midi port, because the port was CTRL and not a number.